he way the hard drive that short-circuit Service

Actually I have seen some cases of this, namely the short-circuit disk. Its short-circuit causes the power supply hard drive is also dead and can not be turned on any computer. Perhaps you have or are experiencing this, that your hard drive short-circuit, when more data is stored in the disk itself. How to drive a short-circuit service?
Below I will try to share about how to service the short-circuit seagate hard drive.
The cause of the short-circuit Seagate hard drive:
The existence of excess voltage from the power supply to the hard drive (Over Voltage)
Preparation Tool:

1.      Star screwdriver: to open the hard drive screws board.
2.      Multitester: to check the short-circuit diode components.
3.      Solder and Tin / tenol: who is used to replace damaged components.
4.      Spare parts diode 1A - 2A: buy electronics stores. 

technique:

• For short-circuit that lies the hard drive components on the inside, you need to open the screw at boardnya.

• For the disk component short-circuit that has been seen directly, you do not need to open boardnya.

• Short-circuit on the hard disk frequently occurs at the voltage of 12 volts DIODE his safety. Voltage 12 voltnya the power supply cables are colored yellow. While the red wire voltage 5 volts. Sometimes DIODE safety voltage of 5 volts was also short-circuit but rarely.

   

 

   

• DIODE safety checks voltnya voltage 12. also check the security DIODE 5 voltnya. see in the picture.

• Immediately replace the hard drive that short-circuit diode diodes tersebut.dengan 1-2 Ampere, purchased at many electronics stores. Note the position of the anode and cathode. Actually, by simply removing the damaged diodes without replacing them, your hard drive will be back to normal. However, this way I do not recommend, because without diode protection if there is no over voltage / overload voltage.

• Try hard drive ready.